DuPont Tychem TK Manuel D'utilisation page 9

4. Make sure that the
gloves and cone are
pushed into the cuff
body with equal pres-
sure all around its cir-
cumference.
5. Locate the locking ring
over the gauntlet of
the gloves and screw
into the cuff body. If
necessary the gauntlet
section of the gloves
can be cut down if
they are causing inter-
ference with the lock-
ing ring.
6. Turn the sleeve the
correct way out
by carefully pulling on
the glove.
It is recommended to do a
pressure test (refer to
page 22) after the gloves
have been changed.
Check that there are no
creases in the outer
Neoprene glove around
the cuff seal. If there are
any creases or the glove
is pinched in any way it
should be removed
and re-fitted. If the cuff
and gloves have been
assembled as described
there should now be a
gas-tight wrist seal.
8
Figure 4
Figure 5
Figure 6