Assembly Of Boot Into Optional Detachable Boot System - DuPont Tychem TK Manuel D'utilisation

Assembly of Boot into optional
detachable Boot System
1. Fit the rubber 'O'ring (D00693) into the groove on the boot seal-
ing collar. Locate the 'O'ring at the bottom of the groove, Fig. 7
& 8
Fig. 7
2. If there is an 'O'ring already fitted, check that it is not dam-
aged. If in doubt fit a new 'O'ring (D00693) the boot sealing col-
lar.
3. With the leg of the suit turned insideout, locate the boot
through the leg sealing collar so that the 'O'ring can be seen
in the groove. Ensure that the boot is facing in the correct
direction, Fig. 9.
Fig. 9
4. Locate the retaining collar (B01603) around the top groove of
the leg sealing collar and snap into position, Fig. 10.
9
Fig. 8
Fig. 10