Abicor Binzel FEC 115 V Mode D'emploi page 41

FEC
6.2.2 Automatic starting functions
Button
I / Power
0 / Error
A / Auto
Tab. 8 Automatic starting functions
6.3 Current clamp (optional)
If required by the welding conditions, a current clamp may be used instead of a ground cable.The clamp is connected to the
FEC by the 4-pole plug and the ground cable or cable assembly is laid in it. Once the welding process begins, the FEC
receives a signal and starts the fume extraction process.
4
1 A / Auto button
Fig. 6 Current clamp
1 Connect the plug with the socket for current clamp (4).
2 Lay the ground cable or cable assembly in the current clamp.
1 Current clamp
Fig. 7 Cable assembly laid in current clamp
NOTICE
• You must ensure that the red dot on the current clamp always faces the direction of the current flow.
3 Press the A / Auto button (1) on the control panel..
The fume extraction system starts automatically when the welding process starts.
BAL.0533.0 • 2019-11-15
Description
Manual
OFF
Integrated automatic Start-Stop system active (system runs only when welding occurs with a
run-on time of approx. 20 seconds)
1
2
3
2 Motor protective switch 3
1
2
3
2 Red dot
Power cable connector 4 Socket for current clamp
3 Cable assembly
6 Commissioning
EN - 13