After Use - DS Produkte VC9388 Mode D'emploi

■ Turn off the device before you remove a water tank.
■ Do not excessively wet the carpet.
1. Determine where you want to start and stop cleaning without stepping on the area
of the carpet that was just cleaned. We recommend that right-handed persons start
on the right carpet border and left handed persons start on the left carpet border.
Cleaning solution may leak out of device once it is deactivated. For this reason, have
a cloth laid out that you can place the device on after use.
2. Completely unwind the mains cord (11) from the hook (10), insert it in the cord brack-
et (14) and connect it with an easily accessible socket whose mains voltage corre-
sponds to the device's technical data.
3. Push the On/Off switch (13) to the I position to turn on the device.
7. Now go over the same strip in reverse. The dirty water will be vacuumed up.
8. Start the next strip slightly overlapping the cleaned carpet strip. Work with even
forward and backward movements up to the other edge of the carpet. In the event of
stubborn dirt, go over a strip of the carpet several times if necessary.
9. Once the dirty water tank (7) fi lls up to the Max mark, it will have to be emptied (see
chapter "After use", section "Cleaning the device").
10. If you would like to empty the dirty water tank, fi ll the fresh water tank or end the
cleaning process, place the device on the cloth you laid out. Turn it off (switch set
to 0) and bring the handle to an upright position.
11. Remove the power plug from the socket.

After use

• Empty both water tanks and clean the fi lters after every use.
• Let the freshly cleaned carpet dry completely.
• Do not step on it as long as it is still wet. If this cannot be avoided, lay out white or
colour-fast cloths and step on them.
• If the cleaning solution ends up on wood fl oors or furniture, wipe it up.
• Vacuum clean the dry carpet with a vacuum cleaner. Use a brush adapter for this (if
possible).
21
4. Step on the pedal (12) and tilt the handle to a position that
is comfortable for you.
5. Run the device to a corner of the carpet.
6. Push the device forward along the carpet border and
depress the button for emitting the cleaning solution (9).
This will apply and brush the cleaning solution into the
carpet. In the process, walk next to the device. Do not
step on the wet carpet! Once you have arrived at the
other end of the carpet, release the button.
EN