Publicité
Les langues disponibles
Les langues disponibles
ramps with suitable resistance, width and length. Load the machine with the
engine switched off, without a driver and pushed by an adequate number of
people. During transport, close the fuel stopcock (if fitted), lower the cutting deck,
engage the parking brake and fasten the machine securely with ropes or chains to
the hauling device.
5.7 ADVICE ON HOW TO OBTAIN A GOOD CUT
1. To keep a lawn green and soft with a good appearance, it should be cut regularly
without damaging the grass.
2. It is always better to cut the grass when dry.
3. The blade must be in good condition and well sharpened so that the grass is cut
straight without any ragged edge that leads to yellowing at the ends.
4. The engine must run at full speed, both to ensure a sharp cut of the grass and to get
the
necessary thrust to push the cuttings through the collector channel.
5. The frequency of mowing should be in relation to the rate of growth of the grass,
which should not be left to grow too much between one cut and the next.
6. During hot and dry periods, the grass should be cut a little higher to prevent the
ground from drying out.
7. If the grass is very tall, it should be cut twice in a twenty four hour period. The first
time at maximum cutting height, possibly reducing the cutting width and the second
cut at the height desired.
8. The appearance of the lawn will improve if you alternate the cutting in both directions.
9. If the collector channel tends to get blocked with grass, you should reduce the
forward speed since this may be too high for the condition of the lawn. If the problem
persists, the probable causes are either the badly sharpened blade or deformed
wings.
10. Be very careful when mowing near bushes or kerbs since these could distort the
horizontal position of the cutting deck, and damage its edge as well as the blade.
2
Page 135 de 160
Publicité
