Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Remove all the separate parts from the packaging,
lay them on the floo and check roughly that all are
there on the base of the assembly steps. Please note
that a number of parts are connected directly to the
main frame preassembled. In addition, there are sev-
eral other individual parts that have been attached to
separate units. This will makes assembly easier and
quicker for you.
Assembly time: 30 - 40 min.
STEP 1:
Attach the stabilizer (69+72).
1. Attach the front stabilizer (69) assembled with
front caps withtransportation roller (70) to main
frame (49) by using bolts M8x45 (73),washers (30),
spring washers (29) and cap nuts (48).
2. Attach the rear stabilizer (72) assembled with
height adjustable caps (71) to main frame (49) by us-
ing bolts (73), washers (30), spring washers(29)and
cap nuts (48). (For uneven floor, you can adjust the
height atrear caps (71) and secure for stable position)
STEP 2:
Attach the pedals (59L+59R).
1. Attach the pedal straps to the pedals (59L+59R).
(The pedal strap andpedals are marked with "L" for
left and "R" for right.)
2. The pedals (59L+59R) are marked with „R" for
right and „L" for left.NOTE: Right and Left are speci-
fied as viewed seated on the machineduring training.
Connect each pedal (59L+59R) to the matching pedal
crank (60L+60R). (NOTE: The right pedal „R" should
be threaded on clockwise. The leftpedal „L" should
be threaded on counter-clockwise.)
STEP 3:
Attach the handlebar support (21) at main frame (49).
1. Push the rubber ring (74) and the support cover
(75) onto handlebarsupport (21).
2. Attach the handlebar support (21) to the holder
at main frame (49) andconnect the plug of connec-
tion cable (22) to motor cable (23).
3. Insert the handlebar support (21) to main frame
(49) and secure by using bolts M8x20 (24), spring
washers (29) and curved washers (25). (Attention:
Ensure that the cable loom are not crunched or
pinchedduring installation.)
4. Push the handlebar support cover (75) with rub-
ber ring (74) into right position to cover up the screw
connection point.
15
GB
Publicité
