Publicité
Les langues disponibles
Les langues disponibles
Log splitter
Safety equipment
Motor circuit breaker
The motor circuit breaker switches the motor off in the event
of overloading of the log splitter. The motor circuit breaker
function should not be deactivated.
Proceed as follows if the motor circuit breaker deactivates the
log splitter:
1.
Disconnect the log splitter from the mains power supply.
2.
Remedy the cause of overloading.
3.
Re-establish the power connection after allowing the unit
to cool for several minutes and switch on the log splitter.
Connection cable
Only rubber cable complying with the H07RN-F quality
standard stipulated in VDE 0282 Part 14 with a wire cross
section of min. 2.5 mm² should be used.
The max. permissible cable length is 10 m. A longer cable
impairs the motor performance and, consequently, the
function of the log splitter.
The connection cable, plug and connection socket should be
free of damage.
Repairs to the connection cable, plug and connection socket
should only be realised by a specialist electrical firm or
workshop. A defective connection cable (e.g. with cracks, cuts
or bends in the insulation) should not be used.
Plug connections should not be exposed to damp or water.
Caution!
Do not damage or sever the connection cable.
Proceed as follows in case of damage:
1.
Disconnect the connection cable immediately from the
mains power supply.
Electrical requirements:
KHS 3700, KHS 5200 models
−
AC 230 V / 50 Hz
−
Min. connection cable cross section = 2.5 mm²
−
Min. mains connection fuse protection = 16 A
Correct use
The log splitter is designed for private use in the home and
garden.
The log splitter is designed exclusively for the following
applications:
−
Splitting freshly-cut timber that does not exceed the
dimensions specified in the technical data.
Incorrect use
−
Splitting of timber containing metal components such as
nails, wire, metal braces, etc. is prohibited
−
Operation in potentially-explosive atmospheres is not
permitted
−
Any other utilisation above or beyond correct use is
prohibited.
Unit description (Illus. A/B)
1
Protection cover
2
Log pusher
3
Log guide tubes
4
Splitting wedge
5
Piston rod
6
Transportation bracket
7
ON/OFF switch on electric motor
8
Operating lever
9
Rear feet (only KHS 5200)
10 Support foot (only KHS 5200)
11 Park position transport wheels
(only KHS 5200)
12 Front feet (only KHS 5200)
13 Front cross member (only KHS 5200)
GB
GB 2
Publicité
