Beta Motorcycles RR 250 2T 2017 Mode D'emploi page 139

- Unscrew filler plug 1 and drain plug 2.
- Drain all the oil from the crankcase.
- Place the cap 2 and tighten to specified
torque.
Pour in the quantity of liquid indicated on
page 16.
Use the oil indicated on page 16 in
the "Recommended lubricants and liquids"
table.
Screw on filler cap 1 again.
WARNING:
Dispose of used oil in compliance with the
regulations in force.
liquid COOlaNT
ChECK ThE lEVEl
Keep the vehicle in vertical position relative
to the ground.
The level of the coolant must be checked
when the engine is cold. Use the following
procedure:
- Unscrew cap 1 and ensure that the liquid
is visible in the lower portion of the load-
ing tube.
- In the case in which the liquid is not visible
remove the vent screw 2 and proceed
topping up.
- At the end of operation refit the filler cap
and the vent screw.
Use the oil indicated on page 16 in
the "Recommended lubricants and liquids"
table.
WARNING: Never unscrew the
filler cap of the radiator when the
engine is hot. Danger of burning!
1
1
1
49
4
2
15Nm
2
GB