EINHELL 34.047.00 Mode D'emploi page 28

Anleitung_GC_PM_46_1_51_1_S_HW_BS_SPK7__ 21.10.13 14:13 Seite 28
GB
10. Faults and remedies for faults
Caution: Always switch off the engine and pull the ignition cable before starting any inspection or adjustment
work.
Caution: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remember that
the exhaust and other parts will get hot. Thus, do not touch parts that emanate heat, as these may burn you.
Important. If problems arise in connection with the engine, please refer to the enclosed manual from
Briggs & Stratton.
Fault
Loud while running, machine
vibrates heavily
Engine does not start
Uneven mowing results
Unsatisfactory bagging of the
grass
28
Possible cause
- Screws are loose
- Blade fasteners are loose
- Blade is unbalanced
- Brake lever not pressed
- Fuel tank is empty
- Blade is blunt
- Cutting height is too low
- Cutting height is too low
- Blade is worn
- Basket is clogged
Remedy
- Check screws
- Check blade fasteners
- Replace blade
- Press brake lever
- Refill with fuel
- Sharpen the blade
- Set correct height
- Set correct height
- Replace the blade
- Empty the basket