Publicité
Les langues disponibles
Les langues disponibles
EN
FR
DE
ES
IT
NL
High
Low
Measured sound values determined according to EN
62841:
A-weighted sound pressure level
Uncertainty K
A-weighted sound power level
Uncertainty K
Wear ear protectors.
Weighted root mean
The vibration total values(triax vector sum) determined
according to EN 62841:
Vibration emission value not
exceed
Uncertainty K
BATTERY
MODEL
PACK
(not included)
RB18L13
RB18L15
RB18L15B
RB18L25
Lithium-ion
RB18L30
RB18L40
RB18L50
RB18L90
OPERATION
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
WARNING
Always wear safety goggles or safety glasses with side
shields when operating products. Failure to do so could
PT
DA
SV
FI
NO
RU
English
Lp = 59 dB(A)
3 dB (A)
LW = 70 dB(A)
3 dB (A)
2
2
COMPATIBLE
CHARGER
(not included)
BCL14181H
BCL14183H
RC18150
RC18627
RC18115
RC18120
RC18118C
PL
CS
HU
RO
LV
LT
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
This product will accept RYOBI ONE+ 18 V lithium-ion
battery packs and RYOBI ONE+ 18 V nickel-cadmium
battery packs.
Always remove battery pack from the product when
cleaning, or when it is not in use. Removing battery
pack will prevent accidental starting that could cause
BATTERY PROTECTION FEATURES
RYOBI 18 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these
built-in features may cause the battery and the tool it is
powering to act differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to stop
running. To reset the battery and tool, release the trigger
and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and tool,
the battery pack is depleted. If depleted, the battery pack
will begin charging when placed on the lithium-ion charger.
TO INSTALL BATTERY PACK (NOT INCLUDED)
See figure 2.
Lock the switch trigger by sliding the switch lock up.
Place the battery pack on the tool.
Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured on the
tool before beginning operation.
When placing battery pack in the tool, be sure raised rib
on battery pack aligns with the bottom of the drill and
latches into place properly. Improper installation of the
battery pack can cause damage to internal components.
2
ET
HR
SL
SK
BG
UK
WARNING
WARNING
CAUTION
TR
EL
Publicité
