Troubleshooting - DS Produkte YPF-6513 Mode D'emploi

EN
1. Fill the water reservoir (7) up to the max marking with tap water (see the "Use" chap-
ter, "Filling the Water Reservoir" section).
2. Attach the iron to the adapter (6) and insert the mains plug into a properly installed
plug socket that is easily accessible.
3. Place the iron with the adapter (6) upright on the ironing board or on a stable, fl at,
heat-resistant and moisture-resistant surface.
4. Heat the device up to the highest temperature setting.
5. Hold the device horizontally over a sink or similar outlet.
9. If you need to, operate the device again for a short time in order to allow any remain-
ing amounts of water to evaporate.

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The device does not
work. The temper-
ature control lamp
does not light up.
No steam is pro-
duced.
28
6. Press the On / Off switch for self-cleaning (11) to the posi-
tion and hold it
7. Allow the water reservoir (7) to empty completely. Tilt the
device back and forth slightly to allow the water to run out
of all nozzles.
8. Repeat the cleaning process several times until no more
limescale residues emerge from the nozzles.
Possible cause / solution
• Is the device connected to the adapter correctly and is the
mains plug pushed all the way into the plug socket?
• Is the socket defective? Try another plug socket and check
the fuse of the mains connection.
• Is the water reservoir empty? Top up the water reservoir.
• The device has not yet reached the operating temperature.
Wait until the temperature control lamp goes out.
• Is the temperature control on a low temperature setting?
Select a higher temperature setting.
• Is the On / Off switch for steam in position
steam generation.
• Press the steam burst button 2 to 3 times to start the
production of steam.
• At high temperatures the steam produced is dry and almost
invisible. This is exacerbated by a high ambient tempera-
ture. Switch the temperature control to a lower temperature
to check whether the device is producing steam.
down.
? Activate