Storage; Self-Cleaning Function - DS Produkte YPF-6513 Mode D'emploi

After Use
1. After ironing, move the On / Off switch for steam (11) to position
the temperature control (14) to the Aus (off) position.
2. Place the device on the adapter (6) or upright on the base (4).
3. Remove the mains plug from the plug socket.
4. Allow the bottom of the iron (8) to cool down completely.
5. Empty the water reservoir (7). Open the water reservoir cap (10), hold the iron over
a sink or similar outlet and turn it upside down. Allow all of the water to run out of the
water reservoir (7).
6. Connect the iron to the mains power again and move the On / Off switch for steam (11)
to position (steam on) and the temperature control (14) to the highest setting for
one to two minutes so that the rest of the water evaporates. Repeat steps 3 to 5.
7. If necessary, wipe down the outside of the device with a soft, slightly damp cloth and
then dry it with a soft cloth.

Storage

1. Once the device has completely cooled down and the water reservoir (7) is empty
(see the "Use" chapter, "After Use" section), place it on the adapter (6).
2. Wind up the mains cable.
3. Store the device in a dry, clean, frost-free place that is not accessible to children and
animals.

Self-Cleaning Function

ATTENTION!
■ Danger of scalding! Hot water and steam will emerge from the bottom of the iron
during the self-cleaning process. Keep the bottom of the iron away from all body parts
and delicate materials when the On / Off button for self-cleaning is pressed!
■ Only ever press the On / Off button for self-cleaning to perform self-cleaning and not
during ironing!
As the temperature drops quickly with this function, we recommend that the iron
should be connected to the adapter (6) and connected to the mains power.
The device has a self-cleaning function allowing limescale residues to be removed from
the device. Additional descaling of the device is not necessary. Perform the following
operations:
27
• Press the spray button (15) a few times. Water will be
sprayed through the spray nozzle (9) onto the fabric.
EN
(steam off) and