Télécharger Imprimer la page

Dustbane 19677 Manuel D'opération page 5

Publicité

Les langues disponibles

Les langues disponibles

- Use manufacturer supplied or approved
replacement parts.
- All repairs must be performed by a qualified
service person.
- Do not modify the machine from its original
design.
6.
When transporting machine:
- Turn machine off.
- Get assistance when lifting machine.
- Use a recommended ramp when loading/
unloading into/off truck or trailer.
- Use tie-down straps to secure machine to
truck or trailer.
7.
This product is classified as RAEE type special
waste and is covered by the requisites of the
new environmental protection regulations
(2002/96/CE RAEE). It must be disposed of
separately from ordinary waste in compliance
with current legislation and standards.
Special waste. Do not dispose of
with ordinary waste.
TECHNICAL CHARACTERISTICS:
Description
Width-including side brush
Length-including side brush
Height-including handle
Machine height W/Handle folded
Maximum sweeping width
Weight
Hopper capacity (real)
Run time
Filtering surface
Productivity Rate-Theoretical
Productivity Rate-Estimat\Actual
Total power consumption
Type of battery
Sound Pressure LpA
MEASURED SOUND POWER LWA
GUARANTEED SOUND POWER LWA,g
Hand vibration HAV
(measurement uncertainty) k
UNPACKING:
Unpack the machine carefully avoiding movements that
can cause damage.
Once the machine is unpacked, check the condition of its
parts. In case the machine is broken in any of its parts,
contact immediately our authorized dealer.
For shipping and packaging purposes, some assembly is
required. For correct assembling instructions, see
machine preparation
Packaging contents:
Machine
Side brush
Use and maintenance manual
Maintenance free type battery
4mm hex wrench
20 amp spare fuse
Charger cord
In the case anything of the above should be missing,
contact immediately our authorized dealer.
Assure that all packaging material (plastics, carton,
pallet, etc.) are collected and stored away from children.
MACHINE PREPARATION:
Side brush assembly:
-Raise the front part of the machine, slide the brush on to
the shaft until it locks into place .
600mm
23,75"
730mm
28,75"
950mm
37,5"
559mm
22"
650mm
25"
53Kg
115lbs
9,3 Lt
1,25 Cu.ft
2h
0,95mq
10 sq.ft
1800mq/h
18000 sq.ft
900 mq/h
9000 sq.ft
360W/18A
360W/18A
42A/5h
57[dB]
62 [dB]
63 [dB]
1,4 [m/sec2]
0,7 [m/sec2]
3

Publicité

loading

Ce manuel est également adapté pour:

Gladiator 464