Worx WG749E Mode D'emploi page 14

VIBRATION INFORMATION
Typical weighted vibration
Uncertainty
WARNING: The vibration emission value during actual
use of the power tool can differ from the declared
value depending on the ways in which the tool is used
dependant on the following examples and other variations
on how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
Using the correct accessory for the tool and ensuring it is
sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if its
use is not adequately managed
WARNING: To be accurate, an estimation of exposure
level in the actual conditions of use should also take
account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle but
not actually doing the job. This may significantly reduce the
exposure level over the total working period.
Helping to minimise your vibration exposure risk.
14
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and
keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration
accessories.
Plan your work schedule to spread any high vibration tool use
across a number of days.
OPERATION INSTRUCTION
NOTE: Read instruction handbook before
operation this machine.
INTENDED USE
This product is intended for domestic lawn mowing.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the handle bar &
Adjusting Handle's height
NOTE: Press and hold
Quick-release button during
operation.
Assembling the grass
collection bag
Cordless Lawn Mower
a = xxm/s²
h
K = 1.5 m/s²
FIGURE
See Fig. A1, A2
See Fig. B
Assembling the grass
collection bag to the lawn
mower
NOTE: Depress the grass
collection bag slightly to
ensure that it is completely
installed.
NOTE: Take the mulching insert
out of the lawn mower before
fitting the grass collection bag.
Removing/emptying grass
collection bag
WARNING! Always check
the safety flap close the
discharge outlet before using.
Never lift the safety flap when
the lawn mower is being used
without fitted grass collection
bag.
Installing mulching insert
Removing /fitting the battery
pack
Insert the safety key before
installing the battery pack.
NOTE: This machine will only
run when sp - batteries are
installed. It is recommended to
use the same AH batteries and
charge the two batteries at the
same time.
When you use two batteries
with different AH, the machine
will only run to the lower
common denominator.
Checking the battery charge
condition
NOTE: Fig. G1 only applies for
the battery pack with battery
indicator light.
Charging the battery pack
NOTE: The batteries are
shipped uncharged. Each
battery must be fully charged
before the first mow.
Always fully charge the two
batteries at same time.
More details can be found in
.
charger's manual
OPERATION
See Fig. C1, C2, C3
See Fig. D1,D2
See Fig. E
See Fig. F1, F2
See Fig.G1
See Fig.G2
EN