Elem Garden Technic TDE3213CBE22 Traduction Des Instructions D'origine page 23

Inspect and maintain the trimmer regularly.

Mains powered trimmers should only be
repaired by an authorized repairer ;
User may carry out maintenance and

adjustments. Please refer to the part of
REPLACEMENT OF THE SPOOL OF NYLON
WIRE.
Use only manufacturers recommended

replacement parts and accessories.(Line:φ
1.2)
TROUBLE-SHOOTING
machine, always unplug the
If the grass trimmer vibrates: remove the spool

and clean its slot carefully removing any grass
and so forth. If vibration persists after
reassembly, replace the spool with a new one.
In the event of the problem not disappearing,
have the trimmer checked at an authorized
service center.
If the grass trimmer does not start: check all the

electrical connections; make sure the safety
circuit-breaker has not been activated; check
that no fuse has blown in your electrical system.
If after the above checks, the grass trimmer still
dose not start, have it checked at an authorized
service center.
STORAGE
Follow these recommendations for storing the grass
trimmer:
Carry out general cleaning of the grass

trimmer and its ancillary parts (see
maintenance paragraph), the prevents mould
from forming.
Store it out of the reach of children, in a stable

and safe position and in a dry place where the
temperature is not too hot or too cold.
Store the trimmer away from direct sunlight, if

possible in a dark or barely lit place.
Do not store in a nylon bag as this could

encourage the formation of damp patches.
Do not store the grass trimmer resting on the

floor. Hang it by the upper handgrip instead, so
that the guard does not touch anything. The
resting of the guard on a surface could alter its
shape and therefore its dimensions and safety
characteristics would be modified.
_ Thoroughly clean the whole machine and its
accessories.
_ Store it out of the reach of children, in a stable and
secure position, in a cool and dry place, avoid too
high and too low temperatures.
_ Protect it from exposure to direct sunlight. Keep it
in the dark, if possible.
_ Don't keep it in plastic bags to avoid humidity
build-up.
Before performing
maintenance to the
machine.
TECHNICAL DATA
Mains voltage
Mains frequency
Power input
No load speed
Max. cutting circle mm
Ref spool
Weight kg
Acoustic pressure level
L 82.9 dB(A)
PA
Acoustic power level
L 92.2 dB(A) K = 1.94 dB(A)
WA
Guaranteed sound power
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard. :
1.907 m/s² K= 1.5 m/²
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
A warning that the vibration emission
during actual use of the power tool can differ
from the declared total value depending on the
ways in which the tool is used and of the need to
identify safety measures to protect the operator
that are based on an estimation of exposure in
the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is
running idle in addition to the trigger time).
230-240V~
50 Hz
250 W
n :10000 min -1
0
220
24405223004
1.2
K = 3 dB(A)
L 94 dB(A)
WA
ATTENTION !
must be worn.
23