Troubleshooting - ECOVACS ROBOTICS WINBOT 850 Mode D'emploi

6. Troubleshooting

NO. Malfunction
Remote Control
1
does not work
Status Indicator
Light flashes BLUE
2
after the product is
placed on the glass
18
EN
Possible Causes
WINBOT 8 is cleaning. When
WINBOT 8 is cleaning, only the
START/PAUSE Button works on
the Remote Control.
The Remote Control is not
paired with WINBOT 8.
WINBOT 8 arrives from the
factory paired with its Remote
Control. If the Remote Control
becomes un-paired or is
replaced, it can be re-paired.
If the Remote Control does not
work and the Status Indicator
Light flashes RED, WINBOT 8
may need to be reset.
The Cleaning Pad is attached
incorrectly and is covering
the Squeegees or the Edge
Detection Sensors.
Edge Detection Sensor
malfunction.
Fan malfunction.
Glass is too dirty for WINBOT 8
to adhere properly.
Solutions
Pause WINBOT 8 by pressing the
START/PAUSE button on the robot
or Remote Control. Other buttons
on the Remote Control will function
when WINBOT 8 is paused.
Power ON WINBOT 8. At the same
time, press and hold START/PAUSE
Button on WINBOT 8 and Pairing
Button on the Remote Control.
Paring is complete when START/
PAUSE Button blinks RED, BLUE
and GREEN.
Reset WINBOT 8 by pressing the
RESET Button on the Remote
Control.
Remove the Cleaning Pad and re-
attach it making sure it is placed
exactly within its Velcro area and
does not cover the Squeegees or the
Edge Detection Sensors.
A. Remove the Cleaning Pad and
re-attach it making sure it does not
cover or affect the Edge Detection
Sensors.
B. Clean the Edge Detection
Sensors as described in section 4.
C. If the problem persists, please
contact Customer Service.
A. Clean the Fan as described in
section 4.
B. If the problem persists, please
contact Customer Service.
Clean a small area on the glass
before use and place WINBOT 8
there.