Place Safety Pod; Spray Cleaning Solution - ECOVACS ROBOTICS WINBOT 850 Mode D'emploi

3.5 Place the Safety Pod
Wipe the surface of the Safety Pod's suction
cup clean with the provided Finishing Cloth.
If WINBOT 8 is being used to clean an inside
window: Press the Safety Pod FIRMLY on
the top corner of the inside window. Make
sure the Safety Pod is attached securely in
place.
If WINBOT 8 is being used to clean an outside
window: Press the Safety Pod FIRMLY on
the inside of the window being cleaned. Make
sure the Safety Pod is attached and securely in
place.

3.6 Spray Cleaning Solution

* It is recommended to use WINBOT with WINBOT Cleaning Solution from ECOVACS. Using
tap water or other cleaners could have an adverse effect on cleaning performance. Using other
cleaning solutions could potentially nullify the warranty.
Spray the upper and lower sides of the
Cleaning Pad with the provided WINBOT
Cleaning Solution 8 times each.
3. Operating WINBOT 8
After spraying, wipe the bottom of WINBOT 8
with the provided Finishing Cloth.
11
EN