ECOVACS ROBOTICS WINBOT 850 Mode D'emploi page 12

3. Operating WINBOT 8
Loop one end of the Safety Tether to
1
End A on the WINBOT 8 Power Cord
and tighten.
2
Connect End A and End B and tighten.
Loop the other end of the Safety
3
Tether around the Safety Pod's
channel and pull it tight.
* If the length of the power cord restricts WINBOT 8's movement, a WINBOT Extension Cord can
be used. Disconnect End A and End B, and connect them with both ends of the Extension Cord
respectively and tighten.
* Only one Extension Cord can be used when WINBOT 8.
10
EN