Publicité
Les langues disponibles
Les langues disponibles
CHAIN OILER
See Figure 15.
Use premium bar and chain lubricant. It is de-
signed for chains and chain oilers and is formu-
lated to perform over a wide temperature range
with no dilution required.
Remove the cap and carefully pour approxi-
mately 2 oz. of bar and chain lubricant into the
bar lube reservoir.
Replace the cap and tighten securely.
Check and refill the bar lube reservoir every time
the pole saw is used.
NOTE: Do not use dirty, used, or otherwise con-
taminated lubricants. Damage may occur to the
oil pump, bar, or chain.
REPLACING THE BAR AND CHAIN
See Figures 16 - 18.
WARNING:
To avoid possible serious injury, stop the motor
and remove the battery pack before replacing
the bar, chain, or performing any maintenance
operation.
Remove the combination wrench from the stor-
age area.
With the combination wrench, remove the chain
cover screw, washer, and chain cover.
The bar contains a slot that fits over the mount-
ing post. The bar also contains a chain tension-
ing pin hole which fits over the chain tensioning
pin inside the chain cover.
Place the bar onto the mounting post.
Fit the chain over the sprocket and into the bar
groove. The cutters on the top of the bar should
face toward the bar tip, in the direction of the
chain rotation.
Replace the chain cover ensuring that the chain
tensioning pin in the cover is in the chain ten-
sioning pin hole in the bar.
MAINTENANCE
TENSIONING PIN
NOTE: If necessary, rotate the chain tensioning
screw counterclockwise until the pin and hole
can be aligned.
Reinstall the washer and screw. Tighten the
screw finger tight only. The bar must be free to
move for tension adjustment.
16 — English
BAR LUBE
RESERVOIR
SPROCKET
MOUNTING
POST
BAR
CHAIN
TENSIONING
PIN HOLE
CHAIN
OIL CAP
Fig. 15
MOUNTING
POST SLOT
CHAIN
COVER
CHAIN
LOCK
COVER
WASHER
SCREW
Fig. 16
Publicité
