Publicité
ASSEMBLY AND DISMANTLING
1. Open the corners in "L" of the structure until are blocked
2. Connect the 2 Arc shaped tubes until fastening pin is fixed to form the upper crossbar
3. Open the textile and insert the top rail, passing over the top of the textile side by side
through the holes provided for this purpose on each side of the same
4. Insert the ends of the arc with the textile on each side of the barrier as shown in the
picture
1
3
5. Extend the textile by the structure
6. Connect the 2 lower tubes as shown in the picture
7. Insert the lower tube (from step 6 ) in the bottom of the fabric as shown in the picture
8.For easily place the other end (end with plastic piece), we must put the barrier in the
lowered position, pulling both click each side up and going to the other end of the piece
as "l". Insert the lower tube in the textile so that the end without plastic cover fixed in the
hollow intended at one end of the leg. (This should be the second step in the dismantling.
The pin is pressed and the bar is removed.)9. Then insert the other end of the lower tube
(the one with plastic cover) in the hollow of the hinge part of the other side of the barrier.
(For removal, the pin is pressed, lowering the plastic cover and removing the lower
extreme tube - this should be the first step of dismantling)
10. Lift and paste the textile Velcro on each leg as shown in the picture
2
4
EN
11
Publicité
