Troubleshooting - Husqvarna 220iL Manuel D'utilisation

3. Continue to turn the the top half of the trimmer head
until the triangles (C) align.
C
4. Remove and discard the remaining trimmer line, if
there is.
5. Cut approximately 5.5 m/18 ft of new trimmer line.
6. Put one end of the trimmer line into one of the holes.
7. Push the trimmer line through the trimmer head and
through the opposite hole.
Keypad
LED display
Green LED flashing
Battery
Condition
The battery warning LED
flashes.
1511 - 003 - 06.11.2020
X X

Troubleshooting

Possible faults
Low battery power.
Possible faults
Temperature deviation, the
battery is too cold or too hot
to use.
The battery is empty.
8. Pull the trimmer line through the trimmer head until
there is an equal length of trimmer line on each side.
9. Hold the trimmer head lower half stable with one
hand.
10. Use your opposite hand to turn the top half
counterclockwise.
11. Continue to turn the knob until approximately 127
mm/5 in of trimmer line is extended from each hole.
Possible action
Charge the battery.
Possible procedure
Let the battery cool down or move it indoors to warm
it up. When the battery has the correct temperature,
it can be used again. Use the battery in ambient tem-
peratures between -10 °C (14 °F) and 40 °C (104
°F).
Charge the battery.
17