Guarantee - Dometic CoolAir SP950C Notice De Montage

Guarantee

Fit the fastening frame and the CoolAir SP950 parking cooler on the
MAN TGA/TGX XLX, XXL as follows:
I
NOTE
Only install the condenser unit after you have attached the
mounting frame on the rear wall of the truck.
➤ Insert and tighten the four M8 x 30 bolts, eight U washers
M8 8.4 x 16 mm and four M8 retaining nuts (fig. 1, page 3) in the mount-
ing frame for the condenser unit.
➤ Remove the existing nuts (fig. 2 1, page 4) from the fastening of the air
filter housing.
➤ Fasten the fastening frame to the fastening bolts using the
M8 8.4 x 20 mm U washers and M8 retaining bolts provided (fig. 2 1,
page 4).
➤ Attach the mounting frame to the bottom of the bracket with the M8 x 16
bolts, U-washers M8 8.4 x 20 mm and M8 retaining nuts provided
(fig. 2 2, page 4).
➤ Place the condenser unit on the projecting bolts of the mounting frame
and bolt to the four U washers M8 8.4 x 16 mm and four M8 retaining
nuts.
➤ Check that all bolts are still tight after travelling approximately 200 km.
7 Guarantee
The statutory warranty period applies. If the product is defective, please
contact the service partner in your country (addresses on the back on the
instruction manual).
Our experts will be happy to help you and will discuss the warranty process
with you in more detail.
8
CoolAir SP950C
EN