Declaration Of Conformity - Beta 1942A Notice D'utilisation Et Instructions

USE
Air supply connection
For correct use of the air saw, always keep to a maximum pressure of 6.2 bars, as measured at the tool inlet. Feed the air saw with
clean, condensate-free air (picture 5). Excessively high pressure or humidity in supply air results in shorter life for the mechanical parts
and may damage the tool.
Start / Stop
To start the air saw, press the start lever, while pushing the safety lever forward (picture 4). Keep the start lever pressed during the job
to be performed. Releasing the lever will cause the air saw to stop quickly.
Blade installation/replacement
Fit the blade into the air saw (picture 3) as follows:
• Loosen the two hexagon screws located at the sides of the air saw body (using a 3-mm hexagon driver), to widen the blade seat
and allow the blade to be fitted in;
• Fit in the air saw blade, pushing it thoroughly. We recommend using Bimetal blades 1942LR;
• Tighten both hexagon screws, locking them uniformly;
• Check that the air saw blade has been secured firmly.
Replace the air saw blade as follows:
• Manually unlock both side hexagon screws (using a 3-mm hexagon driver);
• The air saw blade will be released; it can now be removed;
• Fit in the new air saw blade and follow the above instructions.
Always disconnect air supply before fitting in cutting tools or making adjustments; this precaution will prevent the air saw from being
accidentally started.
Lubrication
The air saw must be connected to a filter-lubricator unit (we recommend Beta item 1919F1/4) provided with an air-oil microfog mixer,
set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool, through the air supply hole
(picture 6).
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel. For such jobs, you can contact Beta Utensili S.P.A.'s repair
centre.
DISPOSAL
The air saw, accessories and packaging should be sent to a waste disposal centre, in accordance with the laws in force in your country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a 12-month warranty for professional
use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective pieces or replacing them at our
discretion.
Should assistance be required once or several times during the warranty period, the expiry date of this warranty will remain unchanged.
We hereby declare, assuming full responsibility, that the described product complies with all the relevant provisions of Machine
Directive 2006/42/EC and amendments thereto, as well as with the following standard:
• EN ISO 11148-12
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18 - 20845 Sovico (MB) - ITALY
Name and title of person in charge
MASSIMO CICERI
(Managing Director)
BETA UTENSILI S.P.A.
Via A. Volta 18
20845 Sovico (MB)
ITALY

DECLARATION OF CONFORMITY

Date 01/01/2015