Battery Replacement; Declaration Of Conformity - Beta 1949 DGT Mode D'emploi

EN
INSTRUCTIONS FOR USE
DIGITAL TYRE INFLATOR
OPERATION
- Dual button: A and B
A - ON-OFF/LIGHT button: quickly push power on/
off button; push and hold for 3 seconds to turn on
the light.
B -
MEASUREMENT UNIT SELECTION button:
quickly push pressure unit switch to select Psi/Bar/
A
KgCm^2/Kpa; push and hold for 3 seconds to reset
to zero.
(please refer to step RESET TO ZERO below)
B
- The tyre inflator can be turned off at any time during
use to save power. Just push the on/off button.
- If the unit is not turned off manually, it will automa-
tically turn itself off after leaving button operation off
for approximately 180 seconds.
- Hard fibreglass reinforced ABS body, hard fibre-
glass reinforced POM trigger, soft plastic bumper and
shockproof, nonslip handle grip.
TECHNICAL SPECIFICATIONS
Pressure increments:0.5 psi /0.05 bar.
-
- LCD screen operating limits:
operating temperature: -10 ÷ +45 °C.
storage temperature range: -20 ÷ +70 °C.
- Functional operating range: 2.0 ÷ 160 psi (0-11 bar)
The unit will read zero "0.0 psig" ("0.00 bar") when actual pressure is below 1.5 psig (0.10 bar).
- Accuracy: 2,0 ÷ 80 psi +/- 1,0 psi; 0 ÷ 5.5 bar +/- 0.07 bar; 81 ÷ 160 psi +/- 1.5 psi;
5.6 ÷ 11 bar +/- 0.1 bar
RESET TO ZERO
1.) Push/hold button (b) for 3 seconds to start calibration. The display will read " -.-.- " during this
stage. The display will then reset to "0.0".
2.) Only calibrate when the unit is disconnected from the air supply. Push the "air release" button to
make sure that no air is in the unit.

BATTERY REPLACEMENT

1.) Carefully push away the battery cover from the rear side of the tyre inflator.
2.) Pick up the old battery and replace it with a new one (AAA size 1.5V battery). Check for correct
battery orientation (+/-).
Caution: always check and set pressure when the tyre is cold.

DECLARATION OF CONFORMITY

The product complies with Directive 2004/108/EC (EMC)
3