Publicité
OUTPUT
Voltage Range:
Current Range:
Output Voltage Setting:
Output Current Setting:
Operating Mode:
Output Switch:
Output Terminals:
Output Impedance:
Output Protection:
Load & Line Regulation:
Ripple & Noise
(20MHz bandwidth):
Transient Response:
Temperature Coefficient:
Status Indication:
METER SPECIFICATIONS
Meter Types:
Meter Resolutions:
Meter Accuracies:
GENERAL
AC Input:
Power Consumption:
Operating Range:
Storage Range:
Environmental:
Safety:
EMC:
Size:
Weight:
0V to 35V minimum
0A to 5A minimum
By coarse and fine controls.
By single logarithmic control.
Constant voltage or constant current with automatic cross-over.
Electronic. Preset voltage and current displayed when off.
4mm terminals on 19mm (0.75") pitch.
Typically <5mΩ in constant voltage mode.
Typically >20kΩ in constant current mode.
Output will withstand up to 40V forward voltage.
Reverse protection by diode clamp for reverse currents up to 3A.
<0.01% of maximum output for a 90% load change or 10% line
change.
Typically <2mVrms, <10mV pk-pk, constant voltage mode.
<200µs to within 50mV of set level for 90% load change.
Typically <100ppm/°C
Output on lamp. Constant current mode lamp.
Dual 3 digit meters with 14mm (0.56") LEDs. Reading rate 4 Hz.
100mV, 10mA
Voltage 0.3% of reading ± 1digit,
Current 0.6% of reading ± 1digit
220V-240V AC ± 10%, 50/60Hz.
110V-240V AC ± 10% by factory option.
Installation Category II.
400VA max.
+5ºC to +40ºC, 20% to 80% RH.
−40ºC to + 70ºC.
Indoor use at altitudes up to 2000m, Pollution Degree 2.
Complies with EN61010−1.
Complies with EN61326.
140 x 160 x 320mm (WxHxD).
2.8kg
Specification
3
Publicité
