Publicité
The EX355 is an exceptionally compact and lightweight single output laboratory dc power supply
providing 0 to 35V at 0 to 5A.
The EX355 uses mixed−mode regulation technology which combines switch−mode
pre−regulation with linear post−regulation. Special techniques are used to maintain very high
efficiency whilst achieving noise levels that are close to that of a pure linear regulator.
Excellent line and load regulation are matched by low noise and good transient response. High
power efficiency ensures that the unit remains cool without any fan noise. High resolution
controls allow accurate setting of voltage and current levels.
The output operates in constant voltage or constant current mode with automatic cross-over and
mode indication. There is a DC output on−off switch.
The EX series incorporates separate digital voltage and current meters on each output. The
meters use bright 14mm (0.56") LED displays and have an update rate of 4 per second providing
near instantaneous response. Simultaneous metering of voltage and current provides accurate
information "at a glance" and avoids any possibility of misinterpretation. When the output switch is
set to "off", the current limit setting is displayed enabling conditions to be set before the load is
connected.
The EX series has been designed to meet the stringent requirements of the latest relevant IEC
standards for safety and EMC, including harmonics emissions. All outputs are intrinsically short
circuit proof, and are protected against external voltages and reverse currents.
Introduction
Specification
Safety
EMC
Installation
Connections
Operation
Maintenance
Instructions en Francais
Bedienungsanleitung auf Deutsch
Istruzioni in Italiano
Instrucciones en Español
Introduction
Table of Contents
1
3
4
5
6
6
7
8
9
13
17
21
1
Publicité
