Publicité
f Do not install the Air to Water Heat Pump in following places .
f
• The place where there is mineral oil or arsenic acid . There is a chance that parts may get damaged due to burned resin .
The capacity of the heat exchanger may reduce or the Air to Water Heat pump may be out of order .
• The place where corrosive gas such as sulfurous acid gas generates from the vent pipe or air outlet . The copper pipe or
connection pipe may corrode and refrigerant may leak .
• The place where there is a danger of existing combustible gas, carbon fiber or flammable dust . The place where thinner
or gasoline is handled .
• This device must be installed according to the national electrical rules .
• With an outdoor unit having net weight upper than 60 kg, we suggest do not install it suspended on wall, but
CAUTION
considering floor standing one .
f If the outdoor unit is installed at a height, ensure that its base is firmly fixed in position .
f
f Make sure that the water dripping from the drain hose runs away correctly and safely .
f
f When you install the outdoor unit at wayside, you should install it above 2 m height or make sure that the heat from the
f
outdoor unit shouldn't be in direct contact with passersby . (The ground for application :The revision of regulation for
facility in building by the law of the Ministry of Construction and Transportation .
Moving the Outdoor Unit by Wire Rope
Fasten the outdoor unit by two 8 m or longer wire ropes as shown at the
figure . To prevent from damage or scratches, insert a piece of cloth between
the outdoor unit and rope, then move the unit .
❋ ❋ The appearance of the unit may be different from the picture depending
on the model .
ENGLISH-9
Wire rope
Plate protection
cloth
Publicité
