Publicité
Setting the option
1 . Press and hold K2 to enter the option setting . (Only available when the operation is stopped)
- If you enter the option setting, display will show the following .
- Seg1 and Seg2 will display the number for selected option .
- Seg3 and Seg4 will display the number for set value of the selected option .
2 . If you have entered option setting, you can shortly press the K1 switch to adjust the value of the Seg1, Seg2 and select
the desired option .
Example)
3 . If you have selected desired option, you can shortly press the K2 switch to adjust the value of the Seg3, Seg4 and change
the function for the selected option .
Example)
4 . After selecting the function for options, press and hold the K2 switch for 2 seconds . Edited value of the option will be
saved when entire segments blinks and tracking mode begins .
• Edited option will not be saved if you do not end the option setting as explained in above instruction .
CAUTION
❋ ❋ While you are setting the option, you may press and hold the K1 button to reset the value to previous setting .
❋ ❋ If you want to restore the setting to factory default, press and hold the K4 button while you are in the option setting
mode .
- If you press and hold the K4 button, setting will be restored to factory default but it doesn't mean that restored setting
is saved . Press and hold the K2 button . When the segments shows that tracking mode is in progress, setting will be
saved .
Optional item
SEG1
0
Channel address
0
0
Base Heater
0
SEG2
SEG3
SEG4
0
A
U
0
0~15
1
0
0
1
0
1
ENGLISH-39
Function of the option
Automatic setting(Factory
default)
Manual adressing
Use(Factory default)
Not use
Remarks
Address for classifying the product
from upper level 0 ~ 15 controller
(DMS, S-NET 3, etc)
-
-
Publicité
