Dyna-Glo DGP483SSN Mode D'emploi page 11

ASSEMBLY INSTRUCTIONS
9. Remove pre-assembled wing nut and plain
washer from the temp gauge (B), then attach
the temp gauge (B) to the grill body assembly
(C). Secure the temp gauge (B) with wing nut
and plain washer removed earlier in this step.
10. Carefully place the grill body (C) onto cart
left side panel assembly (P) and cart right
side panel assembly (L). Adjust the grill body
(C) so that the holes in the grill body (C) are
aligned with holes in the tabs of cart left side
panel assembly (P) and cart right side panel
assembly (L).
Note: Make sure the natural gas hose is inside
the cart. Secure the grill body (C) with four
M6X16 bolts (AA).
Hardware Used
AA M6x16 Bolt
9
10
x 4
11
B
C
C
AA
L