Publicité
Les langues disponibles
Les langues disponibles
•
Changes to the appliance, including replacing the mains cable, must be carried out by a certified installer.
•
Make sure that there is sufficient ventilation and fresh air around the appliance.
UNPACKING
1. Remove the packaging.
2. Examine the appliance for damage.
3. Make sure that the voltage is the same as on the type plate.
PREPARING FOR INSTALLATION
(Figure 3)
(*) The minimum dimension for B1 is 585 mm and the maximum dimension is 595 mm.
Note:
Make sure that the kitchen furniture is prepared according to the dimensions of the appliance.
INSTALLING THE APPLIANCE
Preliminary requirements
•
Make sure that the kitchen furniture is prepared according to the correct dimensions.
Warning:
Two persons are required to install the appliance.
Caution:
Make sure that the mains cable does not get jammed during installation or is placed on top of the
appliance.
Caution:
Do not cover the opening between the kitchen furniture and the top of the appliance. The opening is
required for ventilation.
Note:
It is possible to connect the appliance to the mains supply before positioning the appliance.
Procedure
1. Put the appliance (A) in the center of the kitchen furniture.
Caution:
Make sure that there is a minimum space of 2 mm between the appliance and the walls of the kitchen
furniture.
2. Open the door (E) of the appliance.
3. Place the appliance in the kitchen furniture.
4. Install the plugs (B).
5. Fasten the appliance to the kitchen furniture. Use the screws (D).
6. Install the covers (C).
7. Close the door.
8. Connect the appliance. Refer to section
36
•
English
Connecting the appliance
.
(Figure 4)
Publicité
