Publicité
Les langues disponibles
Les langues disponibles
Removing the oven doors
CAUTION
•
The door is very heavy. Be careful when removing and lifting the door.
•
Do not lift the door by the handle.
Use two hands to remove an oven door. For double ovens, repeat the process
for each door.
A.
Wire Harness
FULL_DOC30x977Dx_DA_DG68-01316A-01_EN+MES+CFR.indb 71
FULL_DOC30x977Dx_DA_DG68-01316A-01_EN+MES+CFR.indb 71
1.
Prior to removing the oven door,
prepare a surface where you will place
it. This surface should be flat and
covered with a soft blanket. You can
also use the corner posts from your
packaging material.
Remove the rubber cap(for LOWER
2.
A
oven door), and then disconnect the
LED light's Wire Harness from the
bottom right of the door.
NOTE
If you are removing the LOWER door, you
must open the lower door to access the wire
harness.
3.
4.
A
B
Oven door hinge lock in
A.
locked position
Oven door hinge lock in
B.
unlocked position
5.
6.
7.
Open the oven door.
Locate the oven door hinge locks in
both corners of the oven door, and then
rotate the hinge locks toward the oven
door to the unlocked position. If the
door hinge lock is not rotated fully (see
illustration B on the left for an example
of full rotation), you will not be able to
remove the door properly.
Partially close the door to engage the
door latch locks. The door will stop at
this point.
Using two hands, grasp the edges of
the oven door. Lift and pull the oven
door toward you and remove. You may
need to gently shift the door from side
to side as you pull.
Set the oven door aside on the
prepared covered work surface with the
oven door resting on its handle.
English 71
2023-03-03 오후 12:05:51
2023-03-03 오후 12:05:51
Publicité
