Maintenance; Cleaning; Sterilization - Carlo De Giorgi Electric Bistoury 645/00 Manuel D'utilisation Et D'entretien

ELECTRIC BISTOURY
ALWAYS SWITCH OFF THE APPLIANCE WHEN YOU FINISH
WORKING WITH IT AND FOLLOWING ALL STOPPAGES,
IRRESPECTIVE OF THE MOTIVE.
IF YOU NOTICE MALFUNCTIONS, STOP THE APPLIANCE
IMMEDIATELY AND DISCONNECT IT FROM THE ELECTRICAL
POWER SUPPLY. BEFORE RECONNECTING THE POWER SUPPLY
FIND THE CAUSE OF THE FAULT AND REMEDY IT. IN THE CASE OF
PROBLEMS, CONSULT CARLO DE GIORGI.

6 - MAINTENANCE

Periodically inspect the accessories, with particular reference to the
condition of the electrodes, and replace them if necessary. Periodically
check the condition of cable insulation. The appliance cables must be
replaced exclusively by suitably skilled and authorised personnel.

6.1 CLEANING

The appliance does not require particular cleaning operations, with the
exception of regular cleaning of the working area: before cleaning the
appliance always disconnect it from the power supply.
Clean the appliance with a soft cloth moistened with approved non-
flammable and non-toxic commercial solvents. Never allow liquids to
penetrate to the internal parts of the appliance. Do not use strong
solvents or sharp/pointed tools.
Use non-flammable cleaning products and liquids that do not conduct
electricity.

6.2 - STERILIZATION

Pay particular attention to cleaning and sterilizing the handpiece and
electrodes, which can be treated in an autoclave for 30 minutes at 127°C
after bagging.
The cable and neutral electrode must be cleaned with alcohol or sterilizing
products.
IMPORTANT: do not sterilize the handpiece with liquids that conduct
electricity.
GB - 10 Carlo de Giorgi