Remove The Battery Pack; Operation; Start The Machine; Stop The Machine - GreenWorks STG401 Manuel De L'utilisateur

EN
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.6

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (15).
2. Remove the battery pack from the machine.
9

OPERATION

Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

START THE MACHINE

1. Push the lock-out button (2) and pull the trigger (1).
9.2

STOP THE MACHINE

1. Release the trigger to stop the machine.
IMPORTANT
WARNING
English
9.3 ADJUST THE LENGTH OF THE
SHAFT
You can adjust the length of the shaft to operate the
machine easily.
1. Stop the machine.
2. Push the lock button (12) and move the lower shaft (7) to
the desired position.
3. Release the lock button.
15
9.4

CHANGE TO THE EDGING MODE

The machine can be used in combination with the edge
guide for edging sidewalks and walkways.
1. Stop the machine and flip down the edge guide from
stored position.
2. Push the lock button (12) and turn the lower shaft 90° or
180° until it engages.
8
NOTE
12
7
NOTE