Table Des Matières - GreenWorks STG401 Manuel De L'utilisateur

1 Description......................................... 4
1.1 Purpose.............................................................. 4
1.2 Overview........................................................... 4
2 Important safety instructions...........4
3 Symbols on the machine................... 5
4 Risk levels...........................................5
5 Service................................................ 6
6 Environmentally safe battery
disposal............................................... 6
7 Proposition 65.................................... 6
8 Installation......................................... 6
8.1 Unpack the machine.......................................... 6
8.2 Attach the edge guide........................................ 7
8.3 Attach the guard.................................................7
8.4 Attach the auxiliary handle................................7
8.5 Install the battery pack.......................................7
8.6 Remove the battery pack................................... 8
9 Operation........................................... 8
9.1 Start the machine............................................... 8
English
9.2 Stop the machine............................................... 8
9.3 Adjust the length of the shaft.............................8
9.4 Change to the edging mode............................... 8
9.5 Operation tips.................................................... 9
9.6 Adjust the length of the cutting line.................. 9
9.7 Line cut-off blade.............................................. 9
9.8 Adjust the cutting diameter..............................10
9.9 Cutting tips...................................................... 10
10 Maintenance.....................................10
10.1 General information.........................................10
10.2 Clean the machine........................................... 10
10.3 Replace the spool............................................. 11
10.4 Replace the cutting line....................................11
11 Transportation and storage............ 12
11.1 Store the machine............................................ 12
12 Troubleshooting............................... 12
13 Technical data.................................. 13
14 Limited warranty............................ 14
15 Exploded view..................................15
3
EN