Adjust The Cutting Diameter; Cutting Tips; Maintenance; General Information - GreenWorks STG401 Manuel De L'utilisateur

EN
when trimming efficiency diminishes. This will maintain best
performance and keep line long enough to advance properly.
9.8 ADJUST THE CUTTING
DIAMETER
The machine is set at a 11 in. (280 mm) cutting diameter.
You can adjust to a 13 in. 330 mm) cutting diameter.
Set the cutting diameter to 11 in. (280 mm) for greater
runtime and 13 in. 330 mm)for a larger cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade (16).
3. Turn the cut-off blade 180°.
4. Tighten the blade screws.
9.9

CUTTING TIPS

• Tilt the machine toward the area to be cut. Use the tip of
the cutting line to cut grass.
• Move the machine from right to left to prevent thrown
debris toward the operator.
• Do not cut in the dangerous area.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
NOTE
16
English
Cut-off
blade
DANGER
AREA
10

MAINTENANCE

Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
10.1

GENERAL INFORMATION

Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
• Stop the machine.
• Remove the battery pack.
• Cool the motor.
• Store the machine in cool and dry place.
• Use correct clothing, protective gloves and safety glasses.
10.2

CLEAN THE MACHINE

• Clean the machine after use with a moist cloth dipped in
neutral detergent.
• Do not use aggressive detergents or solvents to clean the
plastic parts or handles.
• Keep the trimmer head free of grass, leaves, or excessive
grease.
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
10
DIRECTION OF
ROTATION
BEST
CUTTING AREA
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT