Publicité
Les langues disponibles
Les langues disponibles
FINAL OPERATIONS
Once the electrical connections are done and the set up is finished, fasten the cables to the gearmotor jumper
using a cable tie.
Fit the cover and fasten it to the sides using the screws.
ERROR MESSAGE
The error messages appear on the display.
E 1
The travel calibration was interrupted when the STOP button was activated
E 2
Gate-leaf travel calibration incomplete
E 3
Encoder broken
E 4
Services test error
E 7
Insufficient operating time
E 8
The NC contacts are open (for example, the limit-switches)
E 9
Closing obstruction
E 10
Opening obstruction
E 11
Maximum number of detected obstructions
E 14
Serial communication error
E 17
Wireless system error
E 18
The wireless system configuration is missing
Publicité
