CAME BXV Tall Serie Manuel D'installation page 53

Slow-down
F35
sensitivity
Adjusting the
F36
partial opening
Opening slow-
F37
down point
Closing slow-
F38
down point
Managing the
F49 serial con-
nection
F50 Saving data
Reading of
F51
data
Transferring
F52 parameters in
paired mode
Opening
F54
direction
Peripheral
F56
number
Changing COM
F63
speed
Wireless input
F65 RIOED8WS
[T1]
Adjusting obstruction detection sensitivity during slow-down.
10 = maximum sensitivity / ... / 100 = minimum sensitivity (default)
Adjustment as a percentage of total travel, during gate opening.
 This function appears only is the Encoder function is activated.
10 = 10% of the gate travel (default) / ... / 80 = 80% of the door travel
Percentage adjustment of the total door travel, of the opening slow-down starting point.
 This function appears only is the Encoder function is activated.
10 = 10% of the gate-leaf travel / ... / 25 = 25% of the gate-leaf travel (default) / ...
/ 60 = 60% of the gate-leaf travel
Percentage adjustment of the total door travel, from the closing slow-down starting
point.
 This function appears only is the Encoder function is activated.
10 = 10% of the gate travel / ... / 25 = 25% of the gate travel (default) / ... / 60 =
60% of the door travel
To enable the paired operating mode or the CRP (Came Remote Protocol).
0 = Deactivated (default) / 1 = Paired / 3 = CRP
Saving users and settings saved in the Memory Roll.
 This function only appears if a Memory Roll has been plugged into the control
board.
0 = Deactivated (default) / 1 = Activated
Uploading data saved in the Memory Roll.
 This function only appears if a Memory Roll has been plugged into the control
board.
0 = Deactivated (default) / 1 = Activated
Uploading settings from Master to Slave.
 This appears only if function F49 is set to Paired.
OFF = Deactivated (default) / ON = Activated
For setting the gate opening direction.
OFF = Opening left (default) / ON = Opening right
To set the peripheral's number from 1 to 255 for each control board when you have a
system with several operators.
1 ----> 255
For setting the communication speed used in the CRP (Came Remote Protocol)
connection system.
0 = 1200 Baud / 1 = 2400 Baud / 2 = 4800 Baud / 3 = 9600 Baud / 4 = 14400 Baud
/ 5 = 19200 Baud / 6 = 38400 Baud (default) / 7 = 57600 Baud / 8 = 115200 Baud
Wireless safety device (RIOED8WS) associated to a function of choice among those
available: P0 = TOTAL STOP, P7 = reopening during closing, P8 = reclosing during
opening.
For programming, see the instructions that come with the accessory.
 This function only appears if the RIOCN8WS card is plugged into the control board.
OFF = Deactivated (default) / P0 / P7 / P8