Télécharger Imprimer la page

GE JCB800 Manuel Du Propriétaire Et Instructions D'installation page 37

Publicité

Problem
Possible Causes
"F – and a number
You have a function
or letter" flash
error code.
in the display
If the function code repeats. • Disconnect all power to the range for at least 30
Display goes blank
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is turned off from • See the Special features of your oven control section.
showing in the display.
Display flashes
Power failure.
Unable to get the
Oven control pads were
display to show "SF"
not pressed properly.
Power outage,
Power outage or surge.
clock flashes
"Burning" or "oily"
This is normal in a new
odor emitting from
oven and will disappear
the vent
in time.
Strong odor
An odor from the insulation
around the inside of the
oven is normal for the first
few times the oven is used.
No power supply from
Small appliance plug is not
convenience outlet
completely inserted in the
on top of backguard
convenience outlet.
(on some models)
The backguard is too hot
and the convenience outlet
breaker has tripped.
Oven drawer or
A fuse in your home may be
warming drawer
blown or the circuit breaker
will not work
tripped.
Controls improperly set.
Excessive condensation Liquid in drawer.
in the drawer
Uncovered foods.
Temperature setting too high. • Reduce temperature setting.
Food dries out in
Moisture escaping.
the oven drawer or
Drawer not fully closed.
warming drawer
All manuals and user guides at all-guides.com
What To Do
• Press the OFF pad. Put the oven back into
operation.
seconds and then reconnect power. If the function
error code repeats, call for service.
• Replace the fuse or reset the circuit breaker.
• Reset the clock.
• The BAKE and BROIL pads must be pressed
at the same time and held for 3 seconds.
• Reset the clock. If the oven was in use, you must reset
it by pressing the OFF pad, setting the clock and
resetting any cooking function.
• To speed the process, set a self-clean cycle for a
minimum of 3 hours. See the Using the self-cleaning
oven section.
• This is temporary.
• Make sure the small appliance plug is properly
inserted.
• Allow the range to cool, then reset the circuit
breaker by pressing the switch located near the
convenience outlet.
• Replace the fuse or reset the circuit breaker.
• See the Electric warming drawer or Oven drawer section.
• Remove liquid.
• Cover food with lid or aluminum foil.
• Cover food with lid or aluminum foil.
• Push drawer in until latch engages.
www.GEAppliances.ca
37

Publicité

loading

Ce manuel est également adapté pour:

Jcb900