Outdoor FM antenna (aerial)
Receiver
Ground (earth)
wire (not supplied)
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• Keep the satellite radio antenna, away
from the speaker cords and the power cord
to avoid picking up noise.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 62).
• Press DISPLAY so that the frequency
appears on the display.
The system cannot receive satellite
channels at all.
• The receiving condition is not good. Move
the antenna to the place where the
condition is good.
• Check that you subscribed to the desired
satellite radio service (see page 63).
Control for HDMI
The Control for HDMI function does not
work.
• Check the HDMI connection (page 31).
• Make sure "Control for HDMI" is set to
• Make sure the connected component is
• Check the Control for HDMI settings on
To ground
• If you change the HDMI connection,
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
• If the TV does not have System Audio
• You cannot listen to the sound of a
"ON" in HDMI settings menu.
compatible with the Control for HDMI
function.
the connected component. See the
operating instructions of the connected
component.
connect/disconnect the AC power cord, or
there is a power failure, repeat the
procedures of "Preparing for the
"BRAVIA" Sync" (page 89).
System Audio Control function.
Control function, set the "Audio Out"
settings in HDMI settings menu to
– "TV+AMP" if you want to listen to the
sound from the TV speaker and
receiver.
– "AMP" if you want to listen to the
sound from the receiver.
component connected to the receiver while
a TV is selected as the input on the
receiver.
– Change the input of the receiver to
HDMI when you want to watch a
program on a component connected to
the receiver.
– Change the TV channel when you want
to watch a TV broadcast.
– Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
continued
139
GB