Audio Settings - Sony STR-DA4400ES Mode D'emploi

x INPUT (for "Main" only)
Lets you turn on the output of 12V triggers
when the preset input is selected.
When you select "Input," the setting display
which sets each input trigger to on/off appears.
Press V/v to select the input, then press
check the box.
x MAIN (for "Zone2" and "Zone3"
only)
Lets you link operation of trigger in zone 2 or
zone 3 to the main receiver.
Tips
• Even when this receiver is standby mode (press
?/1 on the remote to turned off this receiver), the
receiver in zone 2 or zone 3 remains turned on.
• Only signals from components connected to the
analog input jacks are output through the ZONE 2
OUT/ZONE 3 OUT jacks. No signals are output
from components connected to only the digital
input jacks.
• When SOURCE is selected, the signals input to the
MULTI CHANNEL INPUT jacks are not output
from the ZONE 2 OUT or ZONE 3 OUT jacks
even when the multi-channel input is selected. The
analog audio signals of the current function are
output.
• When "Tuner" is selected; the same type of radio
station (FM/AM) selected in the main zone is set in
zone 2 and zone 3. However, you can select the
input other than "Tuner" in zone 2 and zone 3.
• When the receiver in the main zone is turned off, or
an input source other than "Tuner" is selected, you
can select a radio station from AM or FM in zone
2. When the receiver in the main zone and zone 2
are turned off, you can select a radio station from
AM or FM in zone 3.
When two of the receivers in the main zone, zone 2
or zone 3 are turned off, you can select a broadcast
from FM/AM/XM/SIRIUS in one zone in which
the receiver is turned on.
112
GB

Audio settings

You can make settings for the audio to suit
your preference.
to
A/V Sync (Synchronizes audio
and video output)
Lets you delay the output of audio to minimize
the time gap between audio output and visual
display.
x 0 ms – 300 ms
You can adjust the delay from 0 ms to 300 ms
in 10 ms steps.
Notes
• This function is useful when you use a large LCD
or plasma monitor or a projector.
• This function does not work in the following cases.
– The multi-channel input is selected.
– "2ch Analog Direct" is being used.
Dual Mono (Digital broadcast
language selection)
Lets you select the language you want to listen
to during a digital broadcast. This feature only
functions for Dolby Digital sources.
x MAIN/SUB
Sound of the main language will be output
through the front left speaker, and sound of the
sub language will be output through the front
right speaker simultaneously.
x MAIN
Sound of the main language will be output.
x SUB
Sound of the sub language will be output.