Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Nails
Nail
004310
Handle nails and their box carefully. If the nails have
been handled roughly, they may be out of shape or their
connector breaks, causing poor nail feed.
Humid
Nail
004311
Avoid storing nails in a very humid or hot place or place
exposed to direct sunlight.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge and nails are removed before
attempting to perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Cleaning of magazine
When the pusher in the magazine does not move
smoothly because of dust, sand, chips or other foreign
matters, clean the magazine.
014720
To remove the slide door, loosen the hex bolt on the
magazine.
Hot
1. Hex bolt
1
5
4
014721
Pull the pusher from the slide door and then remove the
stopper, sleeves and springs.
After cleaning, install the whole parts into the slide door.
To install them, take the following procedure.
1.
Install the large spring into the slide door.
2.
Install the parts onto the pusher in the correct
order, sleeve, small spring and then stopper.
3.
Install the pusher with the other parts onto the
slide door.
NOTE:
When you pull out the pusher from the slide door,
•
the parts in the slide door may bounce out.
When you install the pusher with the other parts to
•
the slide door, make slight spaces between the
pusher and sleeves.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Nails
•
Makita genuine battery and charger
•
Safety goggles
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
10
1. Pusher
6
2. Sleeve
3. Spring (large)
4. Spring (small)
5. Stopper
6. Slide door
3
2
1
or
attachments
Only use
accessory or
are
Publicité
Table des Matières
