Publicité
Les langues disponibles
Les langues disponibles
7
TROUBLESHOOTING
PROBLEM
POSSIBLE
CAUSE
The motor does
The power button
not start.
is in the "OFF"
(O) position.
The power cord is
not plugged in.
Electrical outlet
does not supply
sufficient power.
The circuit breaker
is tripped.
The power switch
is on, but you do
not pull the spray
gun trigger.
The machine does
The diameter of
not reach high
garden hose is too
pressure.
small.
Water supply is re-
stricted.
The water supply
is not sufficient.
Spray tip has not
be installed onto
the spray wand
properly.
The water intake
filter is clogged.
English
PROBLEM
SOLUTION
Set the power
switch to the
"ON" ( | ) posi-
tion.
Connect the power
cord to the power
supply.
Try another elec-
trical outlet.
The output pres-
Let it cool, and
sure varies high
start the machine
and low.
again.
Pull the spray gun
trigger.
Replace with a 1"
(25 mm) or 5/8"
(16 mm) garden
hose.
Check garden hose
for kinks, leaks,
and blockage.
Open the water
supply fully.
Install desired
spray tip to end of
wand.
Remove filter and
rinse in warm wa-
ter.
11
POSSIBLE
SOLUTION
CAUSE
The water supply
Open water supply
is not sufficient.
fully. Check gar-
den hose for kinks,
leaks, or blockage.
The pump is draw-
1. Make sure that
ing in air.
the hoses and
fitting are air-
tight.
2. Turn "OFF"
machine.
3. Purge pump
by squeezing
trigger gun un-
til a stead flow
of water
comes out the
spray tip.
The water intake
Remove the filter
filter is clogged.
and Rinse in warm
water.
The supply volt-
Make sure that on-
age is low.
ly the pressure
washer is running
on the circuit.
The gun, hose or
Run distilled vine-
nozzle are calci-
gar through deter-
fied.
gent tank.
EN
Publicité
