Husqvarna PG 690 Manuel D'utilisation page 43

Masquer les pouces Voir aussi pour PG 690:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING: Do not move the product on
steep slopes. Look at the rating plate on the
product for information about the maximum
slope angle.
To move the product down a ramp, operate the
product rearward slowly.
To move the product up a ramp, operate the product
forward slowly.
Do not turn the product more than 45° on a ramp.
To lift the product
WARNING: Make sure that the lifting
equipment has the correct specification to lift
the product safely. The rating plate on the
product shows the product weight.
WARNING: Do not walk or stay below or
near a lifted product. Keep bystanders away
from the risk area. Refer to
on page 10 .
WARNING: Do not lift a damaged product.
Make sure that the lifting eye is correctly
installed and not damaged.
1. Set the product in transport position. Refer to
the product in transport position on page 41 .
2. Attach the lifting equipment at the lifting eye.
To attach the product to a
transportation vehicle
CAUTION: Do not use the support wheel to
attach the product. The support wheel is not
sufficiently stable and can be damaged.
The product has holes that are used with tie-down
straps to attach the product to the transportation vehicle.
1163 - 002 - 24.10.2019
1. Attach the tie-down straps in the holes.
2. Attach and tighten the tie-down straps to the vehicle.
Storage
Work area safety
To set
Disposal
Symbols on the product or the packaging of the product
indicate that this product cannot be handled as domestic
waste. It must be submitted to an appropriate recycling
station for the recovery of electrical and electronic
equipment.
Make sure to disconnect the product from the supply
mains and remove the batteries from the remote control
before submitting to an appropriate recycling station.
Make sure to inform the recycling station that the
product contains a lithium ion battery inside. Submit the
batteries to an appropriate recycling station.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise result
through the incorrect waste management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
4X
CAUTION: Do not put the product in storage
outdoors. Always keep the product indoors.
Keep the product in a dry and frost free area.
Clean the product and do a complete servicing
before you put the product in storage.
Lift the support wheel. The grinding head must be on
the ground.
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Keep the battery charger in a dry and frost free area.
Remove the remote control battery from the remote
control when the product is in storage for more than
6 months.
Charge the product battery each 6 months when the
product is in long-term storage.
43

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pg 690 rcPg 830Pg 830 rc

Table des Matières