Husqvarna PG 690 Manuel D'utilisation page 36

1. Put the front motor cable (A) in front of the grinding
head.
B
A
2. Put the rear motor cable (B) on top of the motor.
3. Push the chassis near the grinding head (C).
4. Put the motor cables through the slot between the
grinding head and the chassis.
36
5. Push the chassis fully against the grinding head (D).
Make sure that the chassis attaches to the bracket
on the grinding head.
C
6. Install the second bracket (E) on top of the bracket
on the grinding head.
7. Tighten the 2 nuts (F) on each side of the grinding
head.
E
D
1163 - 002 - 24.10.2019
F