Ryobi CORNER CAT PCL416 Manuel D'utilisation page 7

For detail sanding such as corners and crevices, use the
tip of the sanding pad with small back and forth motions.
CHANGING SANDING SHEETS AND PADS
See Figure 8, page 9.
To change sheets and pads, simply pull the used sheet off
the base and attach the desired sheet by pressing the sheet
or pad onto the base of the sander.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
Accessories for this product may be ordered online at www.ryobitools.com or where you purchased this product.
 Vacuum adaptor ...............................................................................................................................................A21CCV1
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or ac-
cessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended
can result in serious personal injury.
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
MAINTENANCE
ACCESSORIES
NOTE: ILLUSTRATIONS START ON PAGE 8
7 — English
ROTATING THE SANDING SHEETS
See Figure 9, page 9.
The majority of wear in a precision sanding application
occurs at the tip of the sanding sheet. The unique Tri-Flex
design of the sanding sheets allows you to detach and rotate
the top two thirds of each and extend the life of the sheet.
To rotate the top of the sheet, simply remove the top two
thirds along the perforation. Rotate the sheet so that a clean
corner is located at the tip of the base. Press the sheet firmly
onto the pad.
NOTE: Scrubbing and polishing pads are not perforated
and cannot be rotated.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.