Possible Causes - Gaggia Milano CAREZZA Mode D'emploi

Problem
The machine does not switch on.
The pump is very noisy.
The (14) " ", (18) "
" and (20) " " lights blink
simultaneously.
Coffee is too cold.
The milk does not froth.
It is not possible to prepare a
cappuccino.
Coffee is brewed too fast, crema
does not form.
Coffee does not come out or drips
only.
4219-450-03851 MANUAL GAG. V2 RI8525 GGBF US 1-3L V2.indd 23

Possible Causes

The machine is not connected to the
electric network.
No water in the tank.
This is the first start-up or the machine is
overheated.
The filter holder is not inserted for
preheating (chapter 7).
The cups are cold.
The milk is not suitable: powdered milk,
low-fat milk.
Dirty Pannarello.
No water in the tank.
There is too little coffee in the filter holder. Add coffee (chapter 7).
The grind is too coarse.
Coffee is old or not suitable.
The pod is old or not suitable.
Missing component in the filter holder.
No water.
The grind is too fine.
Coffee tamped in the filter holder.
There is too much coffee in the filter
holder.
The machine has limescale build-up.
The filter in the filter holder is clogged.
Not suitable pod.
ENGLISH
Solution
Connect the machine to the electric network.
Fill the tank up with water and prime the circuit
(section 4.6).
Make sure the tank is full and fully inserted and
lower the temperature as described in section
10.1.
Preheat the filter holder.
Preheat the cups with hot water.
Use whole milk.
Clean the Pannarello as described in chapter 11.
Fill the tank up with water and prime the circuit
(section 4.6).
Use a different blend (chapter 8).
Use a different blend (chapter 8).
Change the pod.
Make sure that all the components are present
and properly installed.
Fill the tank up with water and prime the circuit
(section 4.6).
Use a different blend (chapter 8).
Shake the ground coffee.
Reduce the quantity of coffee in the filter holder.
Descale the machine (chapter 12).
Turn the machine off and let it cool down (approx.
1 hour), then remove and wash the filter holder
thoroughly. If the problem persists, contact the
service centre.
Change type of pod.
23
03/09/2020 10:16:43