Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
20
•
Clean the pressurized filter holder as follows:
-
9
Remove the filter and wash it thoroughly with hot
water.
- Remove the adapter (if fitted), and wash it thoroughly
with hot water.
- Wash the internal part of the pressurized filter holder.
• Do not dry the machine and/or its parts using a microwave
and/or standard oven.
Note: do not wash the pressurized filter holder
in the dishwasher.
12 Descaling
Limescale is a natural part of the water used for machine
operation. It needs to be removed regularly as it may clog the
water and coffee circuit of your appliance.
This is an easy procedure for your Gaggia machine. When the
"
" light (19) turns on, a descaling cycle is recommended.
When the "
" light (19) starts blinking, descaling is
compulsory.
This operation needs to be carried out before
the appliance stops working properly, as in this
case repair is not covered by warranty.
Use the Gaggia descaling product (Fig. B).
Its formula has been designed to ensure
better machine performance and operation for its
whole operating life. If correctly used, it also avoids
alterations in the brewed product. Before starting a
descaling cycle make sure that: THE WATER FILTER (if
used) HAS BEEN REMOVED.
Never drink the descaling solution or any
products dispensed until the cycle has been fully
carried out. Never use vinegar as a descaling solution.
1
13 14
Insert the filter holder (21) into the brew unit (4)
from the bottom. Turn the pressurized filter holder from
left to right until it locks into place. Release the pressurized
filter holder grip. The handle will turn slightly to the left.
This movement guarantees optimum filter holder perfor-
mance.
1
2
Remove and empty the water tank.
3
2
Pour HALF the content of the Gaggia concentrated
descaling solution into the water tank, then fill the tank
with fresh drinking water up to the MAX level.
4
4
Turn on the machine by pressing the ON/OFF button
(11). The "
" light (12) turns on.
4219-450-03851 MANUAL GAG. V2 RI8525 GGBF US 1-3L V2.indd 21
5
Following the instructions provided in chapter 9 of
this manual, dispense 2 cups of water (about 150 ml each)
from the steam wand (Pannarello) and turn the machine
off by pressing the ON/OFF button (11); the "
turns off.
5 Let the descaling solution take effect for approx. 15-20
minutes with the machine turned off.
6 Turn on the machine by pressing the ON/OFF "
button (11).
5
Following the instructions provided in chapter 9 of
this manual, dispense 2 cups of water (about 150 ml each)
from the steam wand (Pannarello). Turn off the machine by
pressing the ON/OFF "
" button (11) and leave it off for 3
minutes.
7 Repeat the operations described in step 6 until the water
tank is completely empty.
During this operation the pump is automatically
disengaged and the "
this is a normal behaviour of the machine. Close the
knob. Wait until the "
" light (14) is steady on before
opening the knob again.
8
2
Rinse the water tank with fresh drinking water and fill
it up.
9 Place a container under the filter holder.
10 Turn on the machine by pressing the "
(11); press the "
" button (13) and dispense the whole
content of the tank by means of the filter holder. Press the
"
" button (13) again to stop the dispensing process.
2
11
Refill the tank with fresh water.
5
Place a large container (about 1 l capacity) under the
steam wand (Pannarello).
Open the water dispensing knob (3) by turning it clock-
wise and dispense the whole content of the water tank by
means of the steam wand (Pannarello).
12
6
After the water dispensing process is complete, close
the water dispensing knob (3) by turning it counter-clock-
wise.
13 Repeat the operations once again from step (8), for a total
of 4 tanks.
14
19
Remove the filter holder from the unit by turning it from
right to left and rinse it with fresh drinking water.
The descaling cycle is now complete.
At the end, press and hold the coffee brewing and steam
dispensing buttons for 3 seconds: the descaling light turns off.
2
Refill the tank with fresh water. If necessary, prime the
circuit as described in section 4.6.
ENGLISH
21
" light (12)
"
" light (20) is blinking:
" ON/OFF button
03/09/2020 10:16:42
Publicité
Table des Matières
