Télécharger Imprimer la page

Bosch B36BT830NS Notice De Montage page 11

Publicité

Les langues disponibles

Les langues disponibles

Installation instructions
The following installation instructions describe the
installation steps for various appliance types.
Therefore the diagrams may be a general representation
of your appliance.
Particular reference is made to special installation steps
for individual appliance types.
1.
Checking the installation enclosure
,
CAUTION:
Use the following check list for a safe and trouble
free installation.
1.
Check the floor.
See section on "Installation/Floor".
2.
Check the dimensions of the installation enclosure,
see "Installation dimensions".
3.
Check that the installation enclosure is square.
4.
Check location of the socket.
See section on "Connecting the power" and in the
section on "Installation dimensions".
5.
Check location of the water connection
(only for appliances with ice maker).
See section on "Connecting the water" and in the
section on "Installation dimensions".
6.
Check attachment of the adjacent cabinet/fixtures.
All cabinet parts in the vicinity of the appliance must
be connected securely to the wall.
7.
Check that adjacent cabinet/fixtures have adequate
clearance (door opening angle).
2.
Removing the packaging
,
WARNING:
Be careful, otherwise people who are helping may
be injured or the appliance may be damaged!
The appliance may tip over while it is being
unpacked.
The appliance is very heavy.
When opening the appliance door,
the appliance may tip forwards.
Note:
Check appliance for damage in transit.
Do not install the appliance if it is visibly damaged.
If in doubt, contact your dealer.
To avoid floor damage:
1.
Remove the packaging carton and be careful not to
damage the surface of appliance.
2.
Place packaging cardboard or plywood under the
appliance.
3.
Remove accessories from the outside
of the appliance.
Save adhesive tape which was used to attach
the supplied accessories to the appliance.
It can be used subsequently for attaching an edge
protection to the installation enclosure walls
(see section on "A / 3. Attaching an edge
protection").
Note:
Do not remove transportation protection device (a)
from the underside of the freezer compartment
drawer.
4.
Remove transportation protection devices (b) and lift
appliance off the pallet – appliance is very heavy!
11

Publicité

loading