Adventys DGIC 3600 Guide D'utilisation page 13

Inattliliing your hob
1) Realize a cut to embed products: 41 X 55 cm
Respect a distance of 5cm with regard to any vertical wall, and an available depth of at least 13 cms
2) Applying a joint in silicone:
A
food joint in silicone (type Novasil S56) must be realized to assure the perfect waterproofness between the
product and the counter.
3) Installing the fixing braket:
The device is delivered with 4 fixing bracket which must be used to maintain the device.
to arrange 2 bracket in front and 2 bracket in the back, which are to be screwed with the existing nuts
along the case of the device.
Step 1:
Placed the supplied clamp
4) Connecting fresh air entrie:
To obtain the best performances of the device, it is advisable to bring of the fresh air through a pipe that
it is necessary to link on the present funnel under the device. The fresh air must be taken in the bottom of
the piece of furniture, in the most convenient place.
Eliectrictli connection
It is necessary to connect your device on a single-phase electricity network 230V, 50Hz or 60Hz.
Maximal power consumed by the device is equal to 3000 or 3600W according to the version of the
device.
The cable of the device not being equipped with power socket. So connet wire NEUTRAL, PHASE and
EARTH(GROUND) of the SINGLE-PHASE electricity network 230V / 32 Aeff on the electric socket by respecting
the locations N for Neutral, L for Phase and GROUND for the GROUND.
Connect the BLUE wire on NEUTRAL of the electric socket.
Connect the BROWN / BLACK wire on PHASE of the electric socket.
Connect the GREEN and YELLOW wire on GROUND of the electric socket.
Step 2:
Placed the washer and nut
It is recommend
Step 3:
Make a silicone seal and tighten the nut
13