Maintenance And Service; Maintenance And Cleaning - Bosch PLL 1 P Notice Originale

22 | English
Fastening/Aligning using the Holder
Using the holder (14), the measuring tool can be fastened as follows:
– Line operation: Hanging it by the recess on its rear, place the holder onto a screw
head slightly projecting out of a wall. Use the magnets (9) to fasten the measuring tool
to the metal surface for line operation (15) of the holder. Turn the upper part of the
holder to align the measuring tool as required.
– Point operation: Using the tripod mount (18), place the holder onto the 1/4" thread
of the tripod and screw it tight using the locking screw of the tripod. Align the tripod
roughly. When working without a tripod, place the holder (14) on a surface that is as
level as possible.
Position the measuring tool with the aluminium supporting surface (2) facing down on
the holder. Use the left magnet (9) (viewed from the front side of the measuring tool)
to attach the measuring tool to the metal surface for point operation (16) of the
holder.
Horizontally align the upper part of the holder using the adjusting screw (17) of the
holder and the spirit level for horizontal alignment (4) of the measuring tool. Turn the
upper part of the holder by 90° and repeat the alignment.
Laser Goggles (Accessory)
The laser goggles filter out ambient light. This makes the light of the laser appear brighter
to the eye.
Do not use the laser goggles as protective goggles. The laser goggles make the
u
laser beam easier to see; they do not protect you against laser radiation.
Do not use the laser goggles as sunglasses or while driving. The laser goggles do
u
not provide full UV protection and impair your ability to see colours.

Maintenance and Service

Maintenance and Cleaning

Keep the measuring tool clean at all times.
Never immerse the measuring tool in water or other liquids.
Wipe off any dirt using a damp, soft cloth. Do not use any detergents or solvents.
The areas around the outlet aperture of the laser in particular should be cleaned on a reg-
ular basis. Make sure to check for lint when doing this.
1 609 92A 56S | (26.08.2019) Bosch Power Tools